Configuration - Siemens PPU 26x.3 series Manual

Spare parts and accessories
9.4 PN/PN coupler
References
Installation and Operating Manual: SIMATIC Bus Links, PN/PN Coupler
support.industry.siemens.com/cs/document/44319532/simatic-bus-links-pnpn-coupler?
dti=0&lc=en-US)
9.4.2

Configuration

Configuring PROFINET components
To configure and analyze PROFINET components, Siemens Industry Online Support provides
the following tools free-of-charge:
● Primary Setup Tool (PST) on the Internet at the following address:
support.automation.siemens.com/WW/view/en/67460624)
Using the Primary Setup Tool (PST), you can configure PROFINET components, e.g. you
can allocate the PN/PN coupler a device name.
● PRONETA on the Internet at the following address:
support.automation.siemens.com/WW/view/en/19440762)
PRONETA (PROFINET network analysis) is a PC tool to analyze PROFINET networks.
Requirements for the configuration (Page 238):
● For the SINUMERIK 828D, the "PN-PN-Coupler20" name is permanently defined;
therefore, the name must be exactly the same in the connected subnet.
● The following IP address is permanently set for the PN/PN coupler: 192.168.214.20
● The I/O address area is 16 bytes from 96 ...111 (index m).
● The PN/PN coupler must be connected to the PROFINET interface X1 of the PPU.
● The PC must be connected with a crossover cable, e.g. via interface X2 on the PN/PN
coupler.
The device name must be configured in the following cases:
● When commissioning for the first time
● When a device is replaced
Example: Configuration with SIMATIC STEP 7
Procedure:
1. Under "Tools" select → "Set PG/PC interface" →"TCP/IP" → "Intel(R) PRO/100 VM".
2. Under "Target system" select → "Edit Ethernet nodes ...".
3. In the "Edit Ethernet Nodes" dialog box, press the "Browse..." button under "Nodes that
can be accessed online".
250
(https://
(http://
(http://
PPU and components
Manual, 10/2015, 6FC5397-2DP40-5BA3