Operator Controls And Displays - Siemens PPU 26x.3 series Manual

Connectable components
7.1 MCP 483 USB
7.1.1

Operator controls and displays

Operator controls (front)
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
⑫
Figure 7-1
NOTICE
Slots for control devices
Do not break out the openings for mounting control devices (risk of damage), rather drill them
to the required width.
Printed slide-in labels are included in the accessory pack for labeling key groups for operation
in milling machines and lathes. You can individually label the customer keys, see Section Spare
parts and accessories (Page 109). Blank slide-in labels are included in the accessory pack.
100
Slot for the Emergency Stop button
JOG and reference point keys
Display for the tool number
Slots for control devices (d = 16 mm, e.g. switch)
Drill mounting holes to install control devices.
Reset button
Keys for operating modes, machine functions and program control
Customer keys
Direction keys with rapid traverse override for lathes and milling machines
Override switch for the spindle
Override switch for the feed control
Keys for spindle control
Keys for feed control
Position of operator controls
PPU and components
Manual, 10/2015, 6FC5397-2DP40-5BA3