Siemens PPU 26x.3 series Manual page 234

Connectable components
7.9 NX10.3 / NX15.3
Pin
3
4
Note
The two terminals "+" and "M" are jumpered in the connector and not in the device. This ensures
that the supply voltage is looped through.
Parameter
Voltage
Current consumption
Max. current via the jumper in the connector
Note
Current consumption
The current consumption increases by the current consumption of DRIVE-CLiQ and the digital
outputs.
X122 digital inputs/outputs pin assignment
Connector designation:
Connector type:
Max. connectable cross-section:
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
An open input is interpreted as "low".
234
Signal name
M (Voltage output)
M (Voltage output)
Signal name Meaning
DI0 Digital input 0
DI1 Digital input 1
DI2 Digital input 2
DI3 Digital input 3
DI16 Digital input 16
DI17 Digital input 17
M1 Reference potential for terminals 1 to 6
M Ground
DI/DO8 Digital input/output 8 (rapid input)
DI/DO9 Digital input/output 9 (rapid input)
M Ground
DI/DO10 Digital input/output 10 (rapid input)
DI/DO11 Digital input/output 11 (rapid input)
M Ground
Meaning
Ground
Ground
Value
24 VDC (20.4 V - 28.8 V)
Max. 0.8 A (without load)
20 A at 55° C
X122
Spring-loaded terminal 1
0.5 mm
2
Manual, 10/2015, 6FC5397-2DP40-5BA3
PPU and components