Siemens SIMATIC ET 200pro Quick Manual page 251

Identification data
Data record 231 – I&M 0 (Identification & Maintenance Function) – provides the
following data from all ET 200pro high feature assemblies.
Byte no. Coding
(hex)
0 ... 1 F1 11
2 ... 3 00 01
4 ... 5 00 36
6 ... 7 00 01
8 ... 9 00 01
10 ... 11 00 2A
12 ... 31 (20 bytes)
32 ... 47 (16 bytes)
48...49 (2 bytes)
50 ... 53 (4 bytes)
54...55 (2 bytes)
56 ... 57 (2 bytes)
58 ... 59 (2 bytes)
60 ... 61 (2 bytes)
62 ... 63 (2 bytes)
Table D-22: Data record 231 - I&M 0 'Identification data'
SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
Meaning
I&M header
SZL-ID
Index (00 42 or 00 01)
Block length (in bytes)
Number of blocks
I&M0 – data block 0
Index (00 42 or 00 01)
MANUFACTURER_ID
ORDER_ID
SERIAL_NUMBER
HARDWARE-REVISION
SOFTWARE-REVISION
REV_COUNTER
PROFILE_ID
PROFILE_SPECIFIC_TYPE
IM_VERSION
IM_SUPPORTED
Data formats and data records
Note
SZL = system state list
I&M 0
For following blocks (56 bytes)
For following blocks (1)
I&M 0
42 = manufacturer designation SIEMENS
Order number
Serial number
Hardware version status or product status
Firmware status
Provides information on parameterized
changes on the module. After each change,
the "REV_COUNTER" is increased.
Provides information on the PROFIBUS pro-
file supported by the device and the
Device family to which the device belongs.
Serves as a supplement to the object
"PROFILE_ID" and contains
An advanced profile specification.
Provides information on the version of the
identification data (01 01
hex
Provides information on the present identifi-
cation data (index 2 to 4).
= Version 1.1).
D-39