Siemens SIMATIC ET 200pro Quick Manual page 231

ID no. Byte Signaling bit
4
1444 22 Manual operation local –
input controls
5
1445 22 Manual local operation – con-
trol device controls
6
1446 22 Manual local operation – PC
controls
Parameters
0
364 8 Parameterization active
1
365 8 Incorrect parameter value
2
366 8 Parameter change illegal in
the ON state
3
368 8 Parameter block CPU / Mas-
ter ON
4
384 8 No external start-up parame-
ters received
5
8 Reserved = 0
6
371 8 Memory module defective
7
370 8 Memory module not plugged
Device function
0
379 9 Self-test active
1
380 9 Self-test OK
2
381 9 Error in self-test
3
369 9 Factory setting
restored
4...5
9 Memory module
372
373
374
Table D-10: Data record 92 – read device diagnosis (Continued)
SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
1)
F no.
—
2)
—
—
—
F16
(F24)
—
—
—
—
F26
(F24)
—
—
—
F9
—
—
Data formats and data records
Meaning / Acknowledgment
Manual operating mode – local active,
+ input controls active
Not supported
Manual operating mode – local active,
+ PC controls active
Signaling bit is continuously updated
Signaling bit is always deleted if acknowl-
edged with trip reset or valid parameter
received.
Leads to tripping on start-up
Attempted parameter change with motor run-
ning or device function concerned that caused
tripping.
Signaling bit is always deleted if acknowl-
edged with trip reset or valid parameter
received.
Signaling bit is continuously updated
Motor starter ignores parameters from the
PLC
Signaling bit is always deleted on change
from start-up to normal operating mode
Signaling bit is always deleted if acknowl-
edged with trip reset.
Leads to tripping on start-up
Signaling bit is continuously updated
Signaling bit is continuously updated
Signaling bit is continuously updated
Signaling bit can only be deleted by switch-
ing the supply voltage (DC 24 V-NS) off / on
when the error cause has been removed.
Signaling bit is always deleted if acknowl-
edged with 'trip reset'.
00 : not used (state after power on)
01 : programming active
10 : programming successful
11 : Programming defective F26,
(F24 only for start-up)
Signaling bit is always deleted when
acknowledged with trip reset.
D-19