Siemens SIMATIC ET 200pro Quick Manual page 243

D.4 Device parameters
If the DP V1 functions are used, complete data records can be interchanged
with the starters across the ET 200pro rear-wall bus. The telegram traffic
between the interface module and the special modules or motor starters takes
place in blocks of up to 16 bytes in length. In each case, the complete block of a
data record must be transferred.
For extended parameterization of the ET 200pro starters, the following ele-
ments of data record 131 (1st block / 62 bytes) are used:
ET 200
pro
DS 131
RPM
Byte no.
Byte
No.
0...3 NST2000 header
4...7 Device functions 2
8...11 Device functions 1
12...13 Rated operating cur-
rent
0...7 0...7
1 14 Rated operating cur-
rent I
and and
Rated operating cur-
0...7 0...7
2 15
rent I
0
16 Load type
1
16 Protection against
voltage failure
2...7
16 Reserved
0...7
17 Pre-warning limit
value,
motor heating
4...5 0...1
6 18 Response to over-
load – thermal motor
model
2...7
18 Reserved
0...3 0...3
6 19 Tripping class
4...7
19 Reserved
Table D-18: Data record 131 – device parameters
SIMATIC – ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04
Parameters Value range
In accordance with system specification
Content device-specific
Not accessible via DP V1
Not used
0.15...2 A
A
e
1.5...12 A
A
e
3-phase motor
1-phase motor
yes
no
—
0...95%;
deactivated
Tripping without
restart
Tripping with restart
[1]
Warning
—
CLASS 5
CLASS 10
CLASS 15
CLASS 20
—
Data formats and data records
Increme Factory
nt setting
10 mA 0.15 / 2.0
10 mA 1.5 / 12
[0] [0]
[1]
[1] [1]
[0]
5% 0%
[0]
— [0]
[0]
[2]
[3] — [0]
[0]
[4]
[1]
Relevant for
all starters
DSe, RSe
(ST and HF)
all starters
DSe, RSe (HF);
sDSSte/sDSte,
sRSSte/sRSte
DSe, RSe (HF);
sDSSte/sDSte,
sRSSte/sRSte
DSe, RSe (HF);
sDSSte/sDSte,
sRSSte/sRSte
D-31