Siemens SIMATIC ET 200pro Quick Manual page 186

Parameter assignment
Parameterization active
Incorrect parameter value
Parameter change illegal in the ON state
Incorrect parameter number
Parameter block CPU / Master active
No external start-up parameters received
Statistical data
Maximum pointer deleted
1) Signaling bits that can be reset using "Trip reset"
Table 10-31: Communication – signals (cont.)
Depending on the type, signals are stored in:
• Data record DS 75 (see
• Data record DS 92 (see
• Process image of the inputs PAE
10-46
Signals
)
)
1)
1)
Chapter D.3.5)
Chapter D.3.7)
Meaning
Yes / No
Parameter not correct
Attempted parameter change not permit-
ted when motor is running.
Specifies the first non-accepted parameter
(parameter ID no.)
Motor starter ignores parameters from the
PLC, but informs the PLC that parameters
are OK.
Signal indicating whether new parameters
were received from the PLC after power
ON or motor restart.
Statistical data for preventive diagnosis
has been deleted
SIMATIC - ET 200pro motor starter
GWA 4NEB 950 5661-02 DS 04