Kia 2020 Telluride Owner's Manual page 315

Driving your vehicle
When driving with tire chains
installed
When driving on roads where the
road surface is pitted or has dif-
ferent surface heights.
Driving in these conditions increases
the stopping distance for your vehi-
cle.
The ABS continuously senses the
speed of the wheels. If the wheels
are going to lock, the ABS repeat-
edly modulates the hydraulic brake
pressure to the wheels.
When you apply your brakes under
conditions which may lock the
wheels, you may hear a "tik-tik''
sound from the brakes, or feel a
corresponding sensation in the
brake pedal. This is normal and it
means your ABS is active.
In order to obtain the maximum
benefit from your ABS in an emer-
gency situation, do not attempt to
modulate your brake pressure and
do not try to pump your brakes.
Press your brake pedal as hard as
possible to allow the ABS to control
the force being delivered to the
brakes.
NOTICE
A click sound may be heard in the
vehicle compartment when the
vehicle begins to move after the
vehicle is started. These conditions
are normal and indicate that the
Anti-lock Brake System is function-
ing properly.
Even with the Anti-lock Brake Sys-
tem, your vehicle still requires suffi-
cient stopping distance. Always
maintain a safe distance from the
vehicle in front of you.
Always slow down when cornering.
The Anti-lock Brake System cannot
prevent accidents resulting from
excessive speeds.
On loose or uneven road surfaces,
operation of the Anti-lock Brake
System may result in a longer stop-
ping distance than for vehicles
equipped with a conventional brake
system.
The ABS warning light will stay on
for approximately 3 seconds after
the ENGINE START/STOP button is
ON.
ODEEV068101NR
During that time, the ABS will go
through selfdiagnosis and the light
will go off if everything is normal. If
the light stays on, you may have a
problem with your ABS. Contact an
authorized Kia dealer as soon as
possible.
Brake system
5
5 37