Kia 2020 Telluride Owner's Manual page 159

Features of your vehicle
may make the following training
procedures quicker & easier.)
4. Locate the "learn" or "smart" but-
ton on the device's motor head
unit. Exact location and color of
the button may vary by product
brand. If there is difficulty locat-
ing the "learn" or "smart" button,
reference the device's owner's
manual or contact HomeLink at 1-
800- 355-3515 or on the internet
at www.homelink.com.
5. Press and release the "learn" or
"smart" button on the device's
motor head unit. You have 30
seconds to complete step 6.
6. Return to the vehicle and firmly
press and release the pro-
grammed HomeLink button up to
three times. The rolling code
equipped device should now rec-
ognize the HomeLink signal and
activate when the HomeLink but-
ton is pressed. The remaining two
buttons may now be programmed
if they have not already been pro-
grammed. Refer to "Programming
HomeLink" on page 4-57.
Operating HomeLink
To operate, simply press the pro-
grammed HomeLink button.
Activation will now occur for the
trained product (garage door, secu-
rity system, entry door lock, estate
gate, or home or office lighting). For
convenience, the hand-held trans-
mitter of the device may also be
used at any time. The HomeLink
Wireless Controls system (once pro-
grammed) or the original hand-held
transmitter may be used to activate
the device (e.g., garage door, entry
door lock, etc.). In the event that
there are still programming difficul-
ties, contact HomeLink at 1-800-
355-3515 or on the internet at
www.homelink.com.
Erasing programmed HomeLink
buttons
OON048401NR
To erase the three programmed
buttons (individual buttons cannot
be erased):
Press and hold the left and center
buttons simultaneously, until the
indicator light begins to flash
(approximately 20 seconds).
Release both buttons. Do not hold
for longer than 30 seconds.
HomeLink is now in the train (or
learning) mode and can be pro-
grammed at any time.
Mirrors
4
4 59