Kia 2020 Telluride Owner's Manual page 310

Driving your vehicle
If the EPB is applied while Auto Hold
is activated because of an Electronic
Stability Control (ESC) signal, a
warning will sound and a message
will appear.
OON058076NR
EPB malfunction indicator
This warning light illuminates if the
ENGINE START/STOP button is
changed to the ON position and goes
off in approximately 3 seconds if
the system is operating normally.
OON058126NR
If the EPB malfunction indicator
remains on, comes on while driving,
or does not come on when the
ENGINE START/STOP button is
5 32
changed to the ON position, this
indicates that the EPB may have
malfunctioned.
If this occurs, have your vehicle
checked by an authorized Kia dealer
as soon as possible.
The EPB malfunction indicator may
illuminate when the ESC indicator
comes on to indicate that the ESC is
not working properly, but it does
not indicate a malfunction of the
EPB.
The EPB warning light may illumi-
nate if the EPB switch operates
abnormally. Shut the engine off and
turn it on again after a few minutes.
The warning light will go off and the
EPB switch will operate normally.
However, if the EPB warning light is
still on, have the system checked by
an authorized Kia dealer.
If the parking brake warning light
does not illuminate or blinks even
though the EPB switch was pulled
up, the EPB is not applied.
If the parking brake warning light
blinks when the EPB warning light is
on, press the EPB switch, then pull it
up. Once more press it back to its
original position and pull it back up.
If the EPB warning does not go off,
have the system checked by an
authorized Kia dealer.
Brake system