I/O Terminal Board Terminals Specifications - Panasonic MEWNET-F Technical Manual

2.4.1 I/O Terminal Board Terminals Specifications

MIL connector type
Terminal layout diagrams
- Operating power supply voltage 12V DC type
(AFP87445)
Note:
- Use the power supply cable (APL9511) attached to the I/O terminal board [MIL connector type] for the
power supply.
* The power supply input termial for I/O and the 12 V (+) or 24 V (+) terminals are internally
connected.The supplied power is used to drive transistors of internal circuit.
* The spare power input terminal and spare output terminals are internally connected.When supplying
DC power (5 V to 24 V) at the power supply terminal, you can used the power to operate an input device
connected to an input terminal.
- N. C. means Not Connected.These terminals are not connected internally.
2-14
- Operating power supply voltage 24V DC type
(AFP87446)