I/O Terminal Board (Slave Station) - Panasonic MEWNET-F Technical Manual

4.1.3 I/O Terminal Board (Slave Station)

"FP I/O Terminal Board" is an exclusive I/O terminal for the remote I/O system [MEWNET-F] that can be
controlled as "Slave station" with the CPU on the master station.One unit configure one station, and no
restriction on the usable number of units if it is within the number of total slave stations.The MIL
connector type and the terminal block type are available.
Installation method
To install a unit on DIN reails, use the DIN rail mounting hook which is attached to the mounting plate.
-
Note:
Avoid using rail mounting in locations with sever vibrations and shock. Mount directly to the panel with
screws.
Installation
Align it with the mounting rail groove and push it down to install it.
Removal
To detach a unit from the DIN rail, pull the hook down with a slotted screwdriver.
Reference: For information on the mounting hole dimensions, <Chapter 10 Dimensions>
4-6