Panasonic MEWNET-F Technical Manual page 23

Station number selector
Sets the station number of the master unit in the W/W2 mode.It is not used in the F mode.
Point the arrow to the number to be used.
Mode selector switches
Setting
Operation
mode
Not used
Terminal
station
setting
The swithces are all
set to the OFF
position at the
factory.
Operation
W mode
W2 mode
SW
OFF
1
ON
2 ―
3 ―
4 ―
5 ―
6 ―
7 7: ON, 8: ON
8 7: OFF, 8: OFF
Operatio 1
n mode
2
Baud OFF
rate 3
ON
Note2)
― 4
Note1) The setting of the mode selector switches is reflected in the operation
monitor LEDs.
Note2) In the W2 mode, a unit at 500 kbps and a unit at 250 kbps cannot be
mixed in the same network.
Note3) Be sure the power is off when changing the selector position (except the
terminal station setting).
Setting
01 to 32: Available
Other numbers: The station number setting error occurs.
(Changing station numbers in operation is possible.)
01 to 64: Available
Other numbers: The station number setting error occurs.
(Changing station numbers in operation is possible.)
Operation
W mode
PC link mode
Non-PC link mode
―
―
―
―
―
Terminal station
Not terminal station
W mode W2 mode
OFF ON
OFF OFF
500 kbps
500 kbps
fixed
250 kbps
Always set the switches to the OFF position.
W2 mode F mode
The operation of the
master unit stops when
communication error
occurs.
The operation of the
master unit continues
when communication
error occurs.
F mode
ON
ON
500 kbps fixed
2-5