I/O Allocation; I/O Allocation For Fp1; I/O Allocation For Fp2/Fp2Sh/Fp3/Fp10Sh - Panasonic MEWNET-F Technical Manual

Remote i/o system

Table of Contents

11.6 I/O Allocation

This section describes the I/O numbers to be used for the "I/O link".How I/O numbers should be

allocated will depend on whether you are using the FP1 or FP2/FP2SH/FP3/FP10SH.

On the FP1, I/O number allocated for the I/O link unit is fixed, however, on the

FP2/FP2SH/FP3/FP10SH, it will vary depending on teh connection and setting.

On the FP1, the special area for the I/O link is used.As the I/O numbers are fixed, the location of the I/O

link unit and the I/O points used by the FP1 do not affect the allocation of the FP1.

I/O type

Input relay

X70 to X8F (32 points)

Output relay

Y70 to Y8F (32 points)

On the FP2/FP2SH/FP3/FP10SH, it is treated as remote I/O.I/O numbers will vary depending on the

location of the master units (master 1 to 4) and the station numbers for the slave stations of I/O link unit.

This section describes the number of I/O points of I/O link unit and the allocation.

No. of I/O points

Occupies 32 input points and 32 output points.

I/O numbers are first allocated for the input, then for the output.

When using the "Allocate Remote I/O Map" function of the tool software FPWIN GR, specify "32X32Y".

Allocation example

Communication path: Master 1 (the closest master unit to the CPU)

Base word number: 64 (default value)

I/O link unit station number: No. 1

In the above situcations, I/O numbers are allocated as follows.

X640 to X65F (32 input points)

Y660 to Y67F (32 output points)

Each I/O relay corresponds as follows:

Reference: For information on the remote I/O allocation, <Chapter 6 Remote I/O Map>

11-12

I/O No.

When the corresponding output Y in the FP2/FP2SH/FP3/

FP10SH is turned ON, X70 to X8F will go ON.

When the Y70 to Y8F is turned ON, the corresponding input

X in the FP2/FP2SH/FP3/FP10SH will go ON.

Description

Table of Contents