View Devices Currently On The Access Point/Router Network - NETGEAR WAC124 User Manual

AC2000 802.11ac Wireless Access Point/Router WAC124
Tx B/s. The current transmission (outbound) bandwidth used on the WAN
-
and LAN ports.
Rx B/s. The current reception (inbound) bandwidth used on the WAN and
-
LAN ports.
Up Time. The time elapsed since this port acquired the link.
-
Poll Interval. The interval at which the statistics are updated on this page.
-
7. To manage the polling, do one of the following:
• To change the polling frequency, enter a time in seconds in the Poll Interval
field and click the Set Interval button.
• To stop the polling entirely, click the Stop button.

View devices currently on the access point/router network

You can view the active wired and WiFi devices in the access point/router network. If
you do not recognize a WiFi device, it might be an intruder.
If the access point/router is in router mode, you can also view the VPN devices in the
access point/router network.
To display the attached wired, WiFi, and VPN devices:
1. Open a web browser from a computer or mobile device that is connected to the
access point/router network.
2. Enter http://www.routerlogin.net in the address field.
If you are not connected to the access point/router network but to the same network
as the access point/router, enter the IP address that is assigned to the access
point/router. If you do not know the IP address, see Find the IP address of the access
point/router on page 29.
The Sign-In page displays. You are prompted to sign in with your NETGEAR account.
If the access point/router is not connected to the Internet, you are prompted to sign
in with the local login credentials (see Log in to the access point/router when it is
not connected to the Internet on page 28).
3. Click the Login button.
The NETGEAR Account Login page displays.
4. Enter your registered email address and password and click the LOG IN button.
The BASIC Home page displays.
Maintain and Monitor the Access
Point/Router
153 User Manual