Set Up And Connect The Access Point To Your Network - NETGEAR WAX610 User Manual

Insight Managed WiFi 6 AX1800 Dual Band Access Point WAX610 User Manual
- Mirrors
- Brick
- Concrete
If you are using adjacent access points, use different radio frequency channels to reduce
interference.
Set up and connect the access point to your
network
You can connect the access point to a Power over Ethernet plus (PoE+) switch in your
network. The switch must be connected to a network router that is connected to the
Internet. If you use a PoE+ connection, the access point does not require a power
adapter.
Note: Depending on the product ordered, the package might not include a power
adapter. You power up the access point by connecting it to a PoE+ switch. If you ordered
a package without a power adapter but do not want to use a PoE+ connection, you can
still order a power adapter as an option.
The access point LAN/PoE+ port supports Ethernet speeds up to 2.5 Gbps. The following
figure shows a NETGEAR MS510TXPP switch, which supports speeds of 2.5 Gbps and
higher and can supply PoE+. To allow for this speed, your Internet connection, modem,
and switch all need to support a speed of 2.5 Gbps. If one of these components supports
only 1 Gbps (which is a common speed), the LAN connection functions also at 1 Gbps.
Figure 4. Set up the access point with a PoE+ connection to your network
Install the Access Point in Your
Network and Access It for Initial
Configuration
20 User Manual