NETGEAR WAC124 User Manual page 154

AC2000 802.11ac Wireless Access Point/Router WAC124
5. Select Attached Devices.
Wired devices are connected to the access point/router with Ethernet cables. WiFi
devices are connected to the access point/router through the WiFi network, in either
the 2.4 GHz band or the 5 GHz band. VPN devices are connected over a VPN tunnel
to the access point/router.
The following tables describe the fields on the Attached Devices page.
Field Description
Wired Devices
Status If access control is enabled (see Allow or block device access to your network on page 81),
the access control status of the device in the network (Allowed or Blocked).
IP Address The IP address that is assigned to the device when it joined the access point/router network.
This address can change when a device is disconnected and rejoins the network.
MAC Address The unique MAC address, which does not change.
Device Name The device name, if detected.
Connection For LAN devices, the connection type is always Wired.
Type
Field Description
2.4 GHz Wireless Devices and 5 GHz Wireless Devices
Status If access control is enabled (see Allow or block device access to your network on page 81),
the access control status of the device in the network (Allowed or Blocked).
SSID The service set identifier (SSID) or WiFi network name that the WiFi device is using.
IP Address The IP address that is assigned to the device when it joined the access point/router network.
This address can change when a device is disconnected and rejoins the network.
MAC Address The unique MAC address, which does not change.
Device Name The device name, if detected.
The following information displays only if the access point/router is in router mode.
Field Description
VPN Client Devices
Device Name The device name, if detected.
Maintain and Monitor the Access
Point/Router
154 User Manual