Factory Default Settings - NETGEAR WAC124 User Manual

AC2000 802.11ac Wireless Access Point/Router WAC124

Factory default settings

You can reset the access point/router to the factory default settings, which are shown
in the following table.
For more information about resetting the access point/router to its factory settings, see
Return the access point/router to its factory default settings on page 138.
Table 3. WAC124 access point/router factory default settings
Feature
Login to the local browser interface
Login URL
SSO login
Local login user name
Local login password
System modes
Access point mode
Router mode
DHCP settings
DHCP client
DHCP server
WiFi network
WiFi communication
SSID names
Factory Default Settings and
Technical Specifications
Default Setting
www.routerlogin.net (if the access point/router does not get an IP address from a
DHCP server, the IP address is 192.168.0.100)
MyNETGEAR registered email address and password
The initial log-in requires SSO and a MyNETGEAR account.
admin (case-sensitive, nonconfigurable)
This user name applies only after initial configuration and if the access point/router
is not connected to the Internet.
password (case-sensitive, configurable)
This password applies only after initial configuration and if the access point/router
is not connected to the Internet.
Enabled by default
Disabled by default.
Only after you complete the initial log-in process in access point mode, can you
change the mode to router mode and connect the access point/router to an Internet
modem.
Enabled (LAN client in access point mode. WAN client in router mode.)
Enabled in router mode (does not apply to access point mode)
Enabled for Wireless 1 network
Disabled for Wireless 2 and Wireless 3 networks
Wireless 1 default network: NETGEAR-1
Wireless 2 optional network: NETGEAR-2
Wireless 3 optional network: NETGEAR-3
257 User Manual