Add An Ipv4 Static Route - NETGEAR WAC124 User Manual

AC2000 802.11ac Wireless Access Point/Router WAC124

Add an IPv4 static route

You can add an IPv4 static route to a destination IP address and specify the subnet mask,
gateway IP address, and metric.
To add an IPv4 static route:
1. Open a web browser from a computer or mobile device that is connected to the
access point/router network.
2. Enter http://www.routerlogin.net in the address field.
If you are not connected to the access point/router network but to the same network
as the access point/router, enter the IP address that is assigned to the access
point/router. If you do not know the IP address, see Find the IP address of the access
point/router on page 29.
The Sign-In page displays. You are prompted to sign in with your NETGEAR account.
If the access point/router is not connected to the Internet, you are prompted to sign
in with the local login credentials (see Log in to the access point/router when it is
not connected to the Internet on page 28).
3. Click the Login button.
The NETGEAR Account Login page displays.
4. Enter your registered email address and password and click the LOG IN button.
The BASIC Home page displays.
5. Select ADVANCED > Advanced Setup > Static Routes.
The Static Routes page displays.
6. Click the Add button.
The Static Route page adjusts.
7. In the Route Name field, enter a name for the route.
The name is for identification purposes.
8. To make the route private, select the Private check box.
A private static route is not reported in RIP.
9. To prevent the route from becoming active after you click the Apply button, clear
the Active check box.
In some situations, you might want to set up a static route but keep it disabled until
a later time. By default, the Active check box is selected and a route becomes active
after you click the Apply button.
Manage the Network Settings 122 User Manual