3
Configuring the Switch
CLI – Enter the host ip address, followed by the mail severity level, source and
destination email addresses and enter the sendmail command to complete the
action. Use the show logging command to display SMTP information.
Renumbering the System
Web – Click System, Renumber. Click the Renumber button to renumber the switch.
When prompted, confirm that you want to renumber the switch.
CLI – Use the reload command to restart the switch. When prompted, confirm that
you want to reset the switch.
Console#reload
System will be restarted, continue <y/n>? y
When restarting the system, it will always run the Power-On Self-Test.
Console(config)#logging sendmail host 192.168.1.19
Console(config)#logging sendmail level 3
Console(config)#logging sendmail source-email
bill@this-company.com
Console(config)#logging sendmail destination-email
ted@this-company.com
Console(config)#logging sendmail
Console#
Resetting the System
Web – Click System, Reset. Click the Reset button to reboot the switch. When
prompted, confirm that you want reset the switch.
CLI – Use the reload command to restart the switch. When prompted, confirm that
you want to reset the switch.
Console#reload
System will be restarted, continue <y/n>? y
Note:
When restarting the system, it will always run the Power-On Self-Test.
3-30
Figure 3-20 Renumbering the System
Figure 3-21 Resetting the System
4-22
4-22