Downloading System Software From A Server; Figure 3-9 Copy Firmware; Figure 3-10 Setting The Startup Code - SMC Networks SMC8126L2 Management Manual

3
Configuring the Switch
• File Name – The file name should not contain slashes (\ or /), the leading letter of
the file name should not be a period (.), and the maximum length for file names on
the TFTP server is 127 characters or 31 characters for files on the switch.
(Valid characters: A-Z, a-z, 0-9, ".", "-", "_")
Note:
Up to two copies of the system software (i.e., the runtime firmware) can be stored
in the file directory on the switch. The currently designated startup version of this
file cannot be deleted.

Downloading System Software from a Server

When downloading runtime code, you can specify the destination file name to
replace the current image, or first download the file using a different name from the
current runtime code file, and then set the new file as the startup file.
Web –Click System, File Management, Copy Operation. Select "tftp to file" as the file
transfer method, enter the IP address of the TFTP server, set the file type to
"opcode," enter the file name of the software to download, select a file on the switch
to overwrite or specify a new file name, then click Apply. If you replaced the current
firmware used for startup and want to start using the new operation code, reboot the
system via the System/Reset menu.
If you download to a new destination file, go to the System/File/Set Start-Up menu,
mark the operation code file used at startup, and click Apply. To start the new
firmware, reboot the system via the System/Reset menu.
3-18

Figure 3-9 Copy Firmware

Figure 3-10 Setting the Startup Code