Assigning Static Multicast Groups To Interfaces; Figure 3-109 Mvr Port Configuration - SMC Networks SMC8126L2 Management Manual

3
Configuring the Switch
Web – Click MVR, Port or Trunk Configuration.
CLI – This example configures an MVR source port and receiver port, and then
enables immediate leave on the receiver port.
Console(config)#interface ethernet 1/1
Console(config-if)#mvr type source
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#mvr type receiver
Console(config-if)#mvr immediate
Console(config-if)#

Assigning Static Multicast Groups to Interfaces

For multicast streams that will run for a long term and be associated with a stable set
of hosts, you can statically bind the multicast group to the participating interfaces.
Command Usage
• Any multicast groups that use the MVR VLAN must be statically assigned to it
under the MVR Configuration menu (see"Configuring Global MVR Settings" on
page 3-175).
• The IP address range from 224.0.0.0 to 239.255.255.255 is used for multicast
streams. MVR group addresses cannot fall within the reserved IP multicast
address range of 224.0.0.x.
Command Attributes
• Interface – Indicates a port or trunk.
• Member – Shows the IP addresses for MVR multicast groups which have been
statically assigned to the selected interface.
• Non-Member – Shows the IP addresses for all MVR multicast groups which have
not been statically assigned to the selected interface.
3-180

Figure 3-109 MVR Port Configuration

4-219
4-219
4-219