Show Log; Table 4-20 Show Logging Trap - Display Description - SMC Networks SMC8126L2 Management Manual

4
Command Line Interface
The following example displays settings for the trap function.
Console#show logging trap
Syslog logging: Enable
REMOTELOG status: disable
REMOTELOG facility type: local use 7
REMOTELOG level type: Debugging messages
REMOTELOG server IP address: 1.2.3.4
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
REMOTELOG server IP address: 0.0.0.0
Console#
Field
Syslog logging
REMOTELOG status
REMOTELOG
facility type
REMOTELOG level type The severity threshold for syslog messages sent to a remote server as specified in
REMOTELOG
server IP address
Related Commands
show logging sendmail (4-52)

show log

This command displays the system and event messages stored in memory.
Syntax
show log {flash | ram} [login] [tail]
• flash - Event history stored in flash memory (i.e., permanent memory).
• ram - Event history stored in temporary RAM (i.e., memory flushed on
power reset).
• tail - Shows event history starting from the most recent entry.
• login - Shows the login record only.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
This command shows the system and event messages stored in memory,
including the time stamp, message level (page 4-44), program module,
function, and event number.
4-48

Table 4-20 show logging trap - display description

Description
Shows if system logging has been enabled via the logging on command.
Shows if remote logging has been enabled via the logging trap command.
The facility type for remote logging of syslog messages as specified in the logging
facility command.
the logging trap command.
The address of syslog servers as specified in the logging host command.