Displaying Lacp Port Counters; Table 3-7 Lacp Port Counters - SMC Networks SMC8126L2 Management Manual

3
Configuring the Switch
CLI – The following example configures LACP parameters for ports 1-4. Ports 1-4
are used as active members of the LAG.
Console(config)#interface ethernet 1/1
Console(config-if)#lacp actor system-priority 3
Console(config-if)#lacp actor admin-key 120
Console(config-if)#lacp actor port-priority 128
Console(config-if)#exit
. .
.
Console(config)#interface ethernet 1/4
Console(config-if)#lacp actor system-priority 3
Console(config-if)#lacp actor admin-key 120
Console(config-if)#lacp actor port-priority 512
Console(config-if)#end
Console#show lacp sysid
Port Channel
-------------------------------------------------------------------------
1
2
3
4
Console#show lacp 1 internal
Port channel : 1
-------------------------------------------------------------------------
Oper Key : 120
Admin Key : 0
Eth 1/1
-------------------------------------------------------------------------
LACPDUs Internal:
LACP System Priority: 3
LACP Port Priority:
Admin Key:
Oper Key:
Admin State : defaulted, aggregation, long timeout, LACP-activity
Oper State:
.
.
.

Displaying LACP Port Counters

You can display statistics for LACP protocol messages.
Field
LACPDUs Sent
LACPDUs Received
Marker Sent
Marker Received
3-86
System Priority
3
32768
32768
32768
30 sec
128
120
120
distributing, collecting, synchronization,
aggregation, long timeout, LACP-activity

Table 3-7 LACP Port Counters

Description
Number of valid LACPDUs transmitted from this channel group.
Number of valid LACPDUs received on this channel group.
Number of valid Marker PDUs transmitted from this channel group.
Number of valid Marker PDUs received by this channel group.
System MAC Address
00-12-CF-31-31-31
00-12-CF-31-31-31
00-12-CF-31-31-31
00-12-CF-31-31-31
4-116
4-133
4-134
4-136
4-136
4-136