Mvr (Interface Configuration) - SMC Networks SMC8126L2 Management Manual

mvr (Interface Configuration)

This command configures an interface as an MVR receiver or source port using the
type keyword, enables immediate leave capability using the immediate keyword, or
configures an interface as a static member of the MVR VLAN using the group
keyword. Use the no form to restore the default settings.
Syntax
[no] mvr {type {receiver | source} | immediate | group ip-address}
• receiver - Configures the interface as a subscriber port that can receive
multicast data.
• source - Configure the interface as an uplink port that can send and receive
multicast data for the configured multicast groups.
• immediate - Configures the switch to immediately remove an interface from
a multicast stream as soon as it receives a leave message for that group.
• ip-address - Statically configures an interface to receive multicast traffic
from the IP address specified for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
Default Setting
• The port type is not defined.
• Immediate leave is disabled.
• No receiver port is a member of any configured multicast group.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Multicast Filtering Commands
4
4-219