Igmp Query Commands (Layer 2); Ip Igmp Snooping Querier; Ip Igmp Snooping Query-Count - SMC Networks SMC8126L2 Management Manual

4
Command Line Interface

IGMP Query Commands (Layer 2)

Command

ip igmp snooping querier

ip igmp snooping
query-count
ip igmp snooping
query-interval
ip igmp snooping
query-max-response-time
ip igmp snooping
router-port-expire-time
ip igmp snooping querier
This command enables the switch as an IGMP querier. Use the no form to disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
If enabled, the switch will serve as querier if elected. The querier is
responsible for asking hosts if they want to receive multicast traffic.
Example
Console(config)#ip igmp snooping querier
Console(config)#

ip igmp snooping query-count

This command configures the query count. Use the no form to restore the default.
Syntax
ip igmp snooping query-count count
no ip igmp snooping query-count
count - The maximum number of queries issued for which there has been
no response before the switch takes action to drop a client from the
multicast group. (Range: 2-10)
4-206
Table 4-69 IGMP Query Commands (Layer 2)
Function
Allows this device to act as the querier for IGMP snooping GC
Configures the query count
Configures the query interval
Configures the report delay
Configures the query timeout
Mode Page
4-206
GC 4-206
GC 4-207
GC 4-208
GC 4-208