whichboot
This command displays which files were booted when the system powered up.
Syntax
whichboot [unit]
unit - Stack unit. (Always unit 1)
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot command. See
the table under the dir command for a description of the file information displayed by
this command.
Console#whichboot
file name
(byte)
------------------------------------
Unit1:
D2218
214124
V2271
1761944
Factory_Default_Config.cfg
5197
Console#
boot system
This command specifies the image used to start up the system.
Syntax
boot system [unit:] {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or code image.
• unit* - Specifies the unit number. (Always unit 1)
* The colon (:) is required.
Default Setting
None
Command Mode
Global Configuration
Flash/File Commands
file type
------------------ -----------
Boot-Rom image
Operation Code
Config File
4
startup size
Y
Y
Y
4-69