Multicast Vlan Registration Commands; Table 4-72 Multicast Vlan Registration Commands - SMC Networks SMC8126L2 Management Manual

- -port - Port number. (Range: 1-29)
• port-channel channel-id (Range: 1-32)
Default Setting
None
Command Mode
Privileged Exec
Command Usage
Using this command without specifying an interface displays all interfaces.
Example
Console#show ip igmp throttle interface ethernet 1/1
Eth 1/1 Information
Status : TRUE
Action : Deny
Max Multicast Groups : 32
Current Multicast Groups : 0
Console#

Multicast VLAN Registration Commands

This section describes commands used to configure Multicast VLAN Registration
(MVR). A single network-wide VLAN can be used to transmit multicast traffic (such
as television channels) across a service provider's network. Any multicast traffic
entering an MVR VLAN is sent to all subscribers. This can significantly reduce to
processing overhead required to dynamically monitor and establish the distribution
tree for a normal multicast VLAN. Also note that MVR maintains the user isolation
and data security provided by VLAN segregation by passing only multicast traffic
into other VLANs to which the subscribers belong.
Command
mvr
mvr
show mvr

Table 4-72 Multicast VLAN Registration Commands

Function
Globally enables MVR, statically configures MVR group
address(es), or specifies the MVR VLAN identifier
Configures an interface as an MVR receiver or source port,
enables immediate leave capability, or configures an
interface as a static member of the MVR VLAN
Shows information about the global MVR configuration
settings, the interfaces attached to the MVR VLAN, or the
multicast groups assigned to the MVR VLAN
Multicast Filtering Commands
Mode
GC
IC
PE
4
Page
4-218
4-219
4-221
4-217