Igmp Query Commands (Layer 2); Table 4-67 Igmp Query Commands (Layer 2) - SMC Networks TigerSwitch SMC8728L2 Management Manual

Example
The following shows the multicast entries learned through IGMP
snooping for VLAN 1:
Console#show mac-address-table multicast vlan 1 igmp-snooping
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1
Console#

IGMP Query Commands (Layer 2)

Command
ip igmp snooping querier Allows this device to act as the
ip igmp snooping
query-count
ip igmp snooping
query-interval
ip igmp snooping
query-max-response-time
ip igmp snooping
router-port-expire-time
ip igmp snooping querier
This command enables the switch as an IGMP querier. Use the no form to
disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
224.1.2.3

Table 4-67 IGMP Query Commands (Layer 2)

Function
querier for IGMP snooping
Configures the query count
Configures the query interval
Configures the report delay
Configures the query timeout
M
ULTICAST
Eth1/11 IGMP
F C
ILTERING OMMANDS
Mode Page
GC
GC
GC
GC
GC
4-245
4-246
4-247
4-247
4-248
4-245