Setting Job During Warm-Up - Konica Minolta bizhub PRESS 1250 User Manual

4.6

Setting Job During Warm-up

4.6 Setting Job During Warm-up
While the machine is warming up after power is turned on, you can select copy conditions and start scanning
so that the machine may start printing immediately when the machine engine is ready.
d
Reference
You can set up the machine to make this function unavailable. Contact your service representative, if desired.
1
Turn ON the sub power switch.
NOTICE
Please do not turn OFF the main power switch. For details on turning on/off the power, please be sure
to consult page 2-49.
2
Display the Copy Screen to check that the message [Ready to set reserve job] is displayed.
% The Wake-up Screen is displayed for a few seconds, followed by the Machine Screen with warm-
up indications. Press the [COPY] tab to change from the Machine Screen to the Copy Screen, then
check that the message [Ready to set reserve job] is displayed.
3
Position the original.
% Position the original FACE UP (with page one UP for double-sided originals) in the ADF. Or, position
the original FACE DOWN on the original glass.
4
Set the desired copy conditions, and enter the print quantity.
5
Press Start on the control panel.
When scanning of the original for the job is started, a dialog will appear on the Copy Screen.
bizhub PRESS 1250/1052
4
4-19