Siemens SIPROTEC 7UT613 series Manual page 4

Preface
Additional Support
Training Courses
Instructions and
Warnings
4
Should further information on the SIPROTEC 4 System be desired or should particular
problems arise which are not covered sufficiently for the purchaser's purpose, the
matter should be referred to the local Siemens representative.
Individual course offerings may be found in our Training Catalogue, or questions may
be directed to our training centre in Nuremberg.
The warnings and notes contained in this manual serve for your own safety and for
an appropriate lifetime of the device. Please observe them!
The following indicators and standard definitions are used:
DANGER
indicates that death, severe personal injury or substantial property damage will
result if proper precautions are not taken.
Warning
indicates that death, severe personal injury or substantial property damage can
result if proper precautions are not taken.
Caution
indicates that minor personal injury or property damage can result if proper precau-
tions are not taken. This particularly applies to damage on or in the device itself and
consequential damage thereof.
Note
indicates information about the device or respective part of the instruction manual
which is essential to highlight.
WARNING!
When operating an electrical device, certain parts of the device inevitably have dan-
gerous voltages.
Death, severe personal injury or substantial property damage can result if the device
is not handled properly.
Only qualified personnel shall work on and around this equipment. It must be thor-
oughly familiar with all warnings and safety notices of this manual as well as with the
applicable safety regulations.
The successful and safe operation of this device is dependent on proper handling, in-
stallation, operation, and maintenance by qualified personnel under observance of all
warnings and hints contained in this manual.
Of particular importance are the general installation and safety regulations for work in
a high-voltage environment (for example, ANSI, IEC, EN, DIN, or other national and
international regulations). These regulations must be observed.
7UT613/63x Manual
C53000-G1176-C160-2