Siemens SIPROTEC 7UT613 series Manual page 368

3 Mounting and Commissioning
Figure 3-13 Position of terminating resistors and the plug-in jumpers for configuration of the RS485 interface
Figure 3-14 Position of the plug-in jumpers for the configuration of the terminating resistors at the Profibus (FMS and
DP), DNP 3.0 and Modbus interfaces
368
Terminating resistors can also be implemented outside the device (e.g. in the plug con-
nectors). In this case, the terminating resistors located on the RS485 or PROFIBUS
interface module must be switched off.
Figure 3-15 Termination of the RS485 interface (external)
7UT613/63x Manual
C53000-G1176-C160-2