Configuring Standard Mode And Fast Mode - Siemens SIMATIC ET 200S Operating Instructions Manual

4.5

Configuring standard mode and fast mode

Introduction
In order to take full advantage of the functionality of the 1SSI for the application in question,
choose between fast mode and standard mode, depending on your automation task.
Areas of Application




Configuring Standard Mode and Fast Mode
Standard Mode
Parameters are assigned to the various modes. You will find the parameter lists in the descriptions of
the modes.
You can integrate the 1SSI in your project in two different ways. Decide whether you want to work
with the GSD file or with STEP 7 using HW Config .
For standard mode, select the 1SSI entry with the
number
6ES7 138-4DB03-0AB0 in the infotext.
Select 6ES7 138-4DB03-0AB0 1SSI for standard
mode.
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07
Closed-loop control applications such as position controls with path position as
actual value
Fast encoder value detection
Monitoring or detecting of position points
Length measurement, edge detection, synchronization with workpieces
Configuring 1SSI with STEP 7 using HW Config
Select an entry from the hardware catalog that corresponds
Drag the entry to the slot at which you have installed your 1SSI.
Select an entry in the GSD file that corresponds to the functionality
4.5 Configuring standard mode and fast mode
Fast Mode
(in isochronous and non-isochronous mode)
to the functionality you want.
For fast mode, select the 1SSI fast mode entry
with the number
6ES7 138-4DB03-0AB0 Fast in the infotext.
Select the parameters.
Configuring 1SSI with the GSD file
(only in non-isochronous mode)
you want.
Select 6ES7 138-4DB03-0AB0 1SSI Fast
for fast mode.
Select the parameters.
1SSI
Mode
Fast
Standard
239