Configuring Port 1 And Port 2; Option Handling; Option Handling And Control Data Record - Siemens SIMATIC ET 200S M151-3 PN Manual

3.2

Configuring port 1 and port 2

Introduction
The interface module IM151-3 PN HIGH FEATURE has two ports, X1P1 and X1P2.
Configuring the ports in HW Config
Configure both ports in the "Properties of IM151-3-PN - Port..." dialog box of HW Config:
● "Addresses" tab: Diagnostic address of the relevant port.
● Topology tab:
● "Options" tab:
Reference
For more information about configuring, refer to the PROFINET system description
(http://support.automation.siemens.com/WW/view/en/19292127) and the
help.
3.3

Option handling

3.3.1

Option handling and control data record

Operating principle
Option handling is a procedure which allows distributed stations with different real
configurations (options) to be operated on the basis of just one configuration. Option
handling is available with and without RESERVE modules and adding options.
Requirements
The parameter "Enable option handling" must be selected during configuration. Control takes
place via a control data record used to define the desired options. The station will not be
operational without a control data record.
Option handling
Option handling is available with and without RESERVE modules and adding options.
Interface module IM151-3 PN HIGH FEATURE (6ES7151-3BA23-0AB0)
Manual, 08/2010, A5E01584258-04
You can specify a "Port interconnection".
To enable port diagnostics, select the following "Connection" setting at "Transmission
Medium/Duplex": "Automatic settings (monitor)".
3.2 Configuring port 1 and port 2
STEP 7
online
Functions
23