Assignment Of The Feedback And Control Interface For The Count Modes - Siemens SIMATIC ET 200S Operating Instructions Manual

2.6.10

Assignment of the Feedback and Control Interface for the Count Modes

Note
For the 1Count24V, the following data of the control and feedback interface are consistent:
Bytes 0 to 3
Bytes 4 to 7
Bytes 8 to 11 (modified user data interface)
Use the access or addressing mode for data consistency over the entire control and
feedback interface on your master (only for configuration using the GSD file).
Assignment Tables
Table 2- 3 Feedback Interface (Inputs)
Address Assignment
Bytes 0 to 3 Count value or stored count value in the case of the latch function on the digital input
Byte 4 Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
Byte 5 Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
Byte 6 Bit 7:
Bit 6:
Bit 5:
Bit 4:
Bit 3:
Bit 2:
Bit 1:
Bit 0:
Byte 7 Reserve = 0
Bytes 8 to 11 Count value
Modified user data interface
1
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07
Short circuit of the encoder supply
Short circuit / wire break / overtemperature
Parameter assignment error
Reserve = 0
Reserve = 0
Resetting of status bits active
Load function error
Load function is running
Down direction status
Up direction status
Reserve = 0
DO2 status
DO1 status
Reserve = 0
DI status
Internal gate status
Zero-crossing in the count range when counting without a main count
direction
Low counting limit
High counting limit
Comparator 2 status
Comparator 1 status
Reserve = 0
Reserve = 0
Synchronization status
1
1Count24V
2.6 Count Modes
Designation
ERR_24V
ERR_DO1
ERR_PARA
RES_STS_A
ERR_LOAD
STS_LOAD
STS_C_DN
STS_C_UP
STS_DO2
STS_DO1
STS_DI
STS_GATE
STS_ND
STS_UFLW
STS_OFLW
STS_CMP2
STS_CMP1
STS_SYN
45