Siemens SIMATIC ET 200S Operating Instructions Manual page 36

1Count24V
2.6 Count Modes
The following conditions apply:
● The counting mode must have been started with the SW gate.
● The "Enable synchronization CTRL_SYN" control bit must be set.
● Synchronize once only: If the enable bit is set, the first edge loads the 1Count24V with
● Synchronization periodically: If the enable bit is set, the first and every further edge loads
● After successful synchronization, the STS_SYN feedback bit is set. It must be reset by
● The signal of a bounce-free switch or the zero mark of a rotary encoder can serve as the
● The STS_DI feedback bit indicates the level of the reference signal.
In isochrone mode, the set feedback bit STS_SYN indicates that the rising edge on the
digital input was between time T
36
the load value.
the 1Count24V with the load value.
the RES_STS control bit.
reference signal.
in the current cycle and time T
i
Operating Instructions, 06/2010, A5E00124867-07
in the previous cycle.
i
Technological Functions