Siemens SIMATIC ET 200S Operating Instructions Manual page 319

● The "DO substitute value" parameter may only have a value not equal to 0 if the
● Different channel-specific parameters are activated depending on the selected operating
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07
"Response to CPU/Master stop" parameter is set to "DO switch substitute value".
mode. The following table lists the active parameters for the individual operating modes.
Parameters that are not listed must be set to 0.
Operating mode
Pulse output
Pulse width modulation
Pulse train
On/Off-delay
Frequency output
5.5 Parameter assignment and compatibility
Short control interface
Time base
On-delay
Function DI
Diagnostics DO
Time base
On-delay
Minimum / Pulse duration
Time period
Output format
Function DI
Diagnostics DO
Time base
On-delay
Minimum / Pulse duration
Time period
Function DI
Diagnostics DO
Time base
On-delay
Diagnostics DO
Time base
On-delay
Output format
Function DI
Diagnostics DO
2PULSE
Long control interface
Time base
Function DI
Diagnostics DO
Time base
On-delay
Minimum / Pulse duration
Output format
Function DI
Diagnostics DO
Time base
Function DI
Diagnostics DO
Time base
Diagnostics DO
Time base
Output format
Function DI
Diagnostics DO
319