Parameter Assignment For Measurement Modes - Siemens SIMATIC ET 200S Operating Instructions Manual

1Count24V
2.7 Measurement Modes
2.7.12

Parameter Assignment for Measurement Modes

Introduction
You can use either of the following to assign parameters for the 1Count24V:
● STEP 7 V5.3 SP2 or later
● A GSD file (http://www.automation.siemens.com/csi/gsd)
Parameter List for Measuring Modes
Table 2- 22 Parameter List for Measuring Modes
Parameter
Enable
Group diagnostics
Response to failure of the higher-level controller
Response to CPU/master STOP
Encoder parameters
Signal evaluation A, B
Encoder and input filter
- At count input (track A)
- At direction input (track B)
- At digital input DI
Sensor A, B, DI
Direction input B
Output parameters
Diagnostics DO1
1
Function DO1
Substitute value DO1
82
Value Range
Disable/enable
Turn off DO1/
Continue working mode/
DO1 substitute a value/
DO1 keep last value
Pulse and direction/
Rotary encoder (single)
2.5 µs/25 µs
2.5 µs/25 µs
2.5 µs/25 µs
24V P switch, normal mode/
24V M switch
Normal/Inverted
Off/on
Output/
Outside the limits/
Under the low limit/
Over the high limit
0/1
Default
Disable
Turn off DO1
Pulse and Direction
2.5 µs
2.5 µs
2.5 µs
24V P switch, normal mode
Normal
Off
Output
0
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07