Example: Starting 1Ssi - Siemens SIMATIC ET 200S Operating Instructions Manual

1SSI

4.3 Example: Starting 1SSI

4.3 Example: Starting 1SSI
Introduction
These instructions provide an example to guide you to a functioning application that will
enable you to become familiar and check the basic hardware and software functions of the
1SSI. For this example, you will operate the 1SSI in standard mode, rather than isochronous
mode.
Requirements
The following requirements must be satisfied:
● You must have put an ET 200S station on an S7 station with a DP master into operation.
● You must have the following:
Installation, Wiring and Fitting
1. Install and wire the TM-E15S24-01 terminal module (see Figure).
2. Plug the 1SSI into the terminal module. Detailed instructions are provided in the ET 200S
234
– A TM-E15S24-01 terminal module
– An 1SSI
– An SSI encoder and the necessary wiring material
Distributed I/O Device (http://support.automation.siemens.com/WW/view/en/1144348)
operating instructions.
Figure 4-1 Terminal Assignment for the Example
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07