Siemens SIMATIC ET 200S Operating Instructions Manual page 326

2PULSE
5.7 Application Examples
Parameters
The following parameters are required for channel 0 of the 2PULSE to fill liquids in pulse
output mode.
Table 5- 1 Parameter List for the Filling Process
Parameters
Group diagnosis
Diagnostics DO 0
Response to CPU/master STOP
Mode
Time base
DI function 0
On-delay
The additional parameters of channel 0 of the 2PULSE have no effect on the pulse output
mode.
The parameters for channel 1 are not relevant in this application example.
326
Set Value
Enable
On
Turn off DO 0
Pulse output
1 ms
Input
0
Meaning
The following errors trigger a diagnostic
message:
Short circuit digital output DO

Short circuit of the encoder supply

The 2PULSE detects the short circuit error at
the DO 0 digital output.
All the preset times are specified at a
resolution of 1 ms.
The digital input is used to establish whether
the container is correctly positioned.
The valve is opened immediately with
SW_ENABLE = 1
Operating Instructions, 06/2010, A5E00124867-07
Technological Functions