Siemens SIMATIC ET 200S Operating Instructions Manual page 158

1Count5V
3.6 Count Modes
Control bits Notes
RES_STS Start resetting of status bit
The status bits are reset by means of the acknowledgment process between the RES_STS bit and
the RES_STS_A bit.
SET_DO1 Control bit DO1
Switches the DO1 digital output on and off when CTRL_DO1 is set.
SET_DO2 Control bit DO2
Switches the DO2 digital output on and off when CTRL_DO2 is set.
SW_GATE SW gate control bit
The SW gate is opened/closed via the control interface with the SW_GATE bit.
Notes on the Feedback Bits
Table 3- 7 Notes on the Feedback Bits
Feedback bits Notes
ERR_24V Short circuit of the encoder supply
The error bit must be acknowledged by the EXTF_ACK control bit.
Diagnostic message, if assigned.
ERR_DO1 Short circuit/wire break/overtemperature due to overload at output DO1
The error bit must be acknowledged by the EXTF_ACK control bit.
Diagnostic message, if assigned.
ERR_DO2 Short circuit/wire break/overtemperature at output DO2
The error bit must be acknowledged by the EXTF_ACK control bit.
Diagnostic message, if assigned.
ERR_ENCODER Short circuit / wire break of 5 V encoder signal
The error bit must be acknowledged by the EXTF_ACK control bit.
Diagnostic message, if assigned.
ERR_LOAD Load function error
The LOAD_VAL, LOAD_PREPARE, CMP_VAL1, CMP_VAL2, and C_DOPARAM bits cannot be set
simultaneously during transfer. This results in setting the ERR_LOAD status bit, similar to loading an
incorrect value (which is not accepted).
ERR_PARA Parameter assignment error ERR_PARA
RES_STS_A Resetting of status bits active
STS_C_DN Down direction status
STS_C_UP Up direction status
STS_CMP1 Comparator 1 status
The STS_CMP1 status bit indicates that the output is or was switched on. It must be acknowledged
with the RES_STS control bit. If the status bit is acknowledged when the output is still switched on,
the bit is set again immediately. This bit is also set if the SET_DO1 control bit is used when DO1 is
not enabled.
STS_CMP2 Comparator 2 status
The STS_CMP2 status bit indicates that the output is or was switched on. It must be acknowledged
with the RES_STS control bit. If the status bit is acknowledged when the output is still switched on,
the bit is set again immediately. This bit is also set if the SET_DO2 control bit is used when DO2 is
not enabled.
158
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07