Stopping The Digitizer; Before Switching Off; Switching Off - AGFA DX-G User Manual

DX-G/DX-M

Stopping the digitizer

Before Switching

Switching


Before Switching Off

Check that the digitizer is not scanning an image plate. If the digitizer is
scanning an image plate, the status indicator is flashing green.

Switching Off

It is recommended to switch off the digitizer at the end of the day.
To switch off, press the main switch to the Off ("0") position.
56
Off.
Off.
Note: Only switch off the digitizer if you do not intend to digitize emergency
image plates overnight. Switching on the digitizer takes approximately
3 minutes. During this time emergency digitizing is not possible!
main switch
2321 E EN 20130722