3
Put the cassettes containing the image plate on the cassette buffer [1] of the
digitizer as shown below.
Make sure to insert the cassette with the black (tube) side to the front and with the
shutter opening mechanism and the locking mechanism down, towards the cassette
slot.
Shutter opening and locking
mechanism
As a result, the digitizer starts erasing the image plate and the status indicator is blue
flashing.
When the digitizer has finished erasing the cassette, the status indicator is constantly
lit in blue.
4
Remove the cassette with the erased image plates from the cassette output
buffer.
5
Press the Erase button again to switch to normal mode.
One minute after the last cassette has been processed, the digitizer switches from
"erasure" mode to "normal mode".
2321 E EN 20130722
Tube side of the cassette
Figure 4: Cassette orientation
Note: To re-erase an image plate, you must push the Erase button at the
front side before you insert the cassette. After that, you have 10 seconds to
enter a cassette. If you do not, the digitizer returns to the standby mode.
DX-G/DX-M
59