Setting The Reception Mode - Sharp UX-D50 User Manual

all.book Page 31 Monday, September 1, 2003 3:46 PM

Setting the Reception Mode

Your fax has four modes for receiving incoming faxes:
FAX mode:
Select this mode when you only want to receive faxes on your line. The fax
machine will automatically answer all calls and receive incoming faxes.
TEL mode:
This mode is the most convenient for receiving phone calls. Faxes can also be
received; however, all calls must first be answered by picking up the fax's
handset or an extension phone connected to the same line.
TEL/FAX mode:
This mode is convenient for receiving both faxes and voice calls. When a call
comes in, the fax will detect whether it is a voice call (including manually
dialled faxes), or an automatically dialled fax. If it is a voice call, the fax will
make a special ringing sound to alert you to answer. If it is an automatically
dialled fax, reception will begin automatically.
A.M. mode:
Select this mode when you go out and want the built-in answering system to
answer all calls. Voice messages will be recorded, and fax messages will be
received automatically.
Setting the reception mode
Make sure a document is not loaded in the document feeder, and then
AUFLÖS./
EMPFANG
press
AUFLÖS./
EMPFANG
For more information on receiving faxes in FAX and TEL modes, see Chapter
4, Receiving Faxes. For more information on using A.M. mode, see Chapter 3,
Using the Answering System.
until the arrow in the display points to the desired mode.
1 2 3
4 5 6
7 8 9
0
Setting the Reception Mode
01-JAN 10:30
01-JAN 10:30
AUFLÖS./
EMPFANG
01-JAN 10:30
01-JAN 10:30
TEL FAX
TEL/FAX AB
TEL FAX
TEL/FAX AB
TEL FAX
TEL/FAX AB
TEL FAX
TEL/FAX AB
31