Loading Printing Paper - Sharp UX-D50 User Manual

all.book Page 25 Monday, September 1, 2003 3:46 PM

Loading Printing Paper

You can load up to 50 sheets of A4-size, 60 - 80 g/m
(at room temperature; maximum stack height should not be higher than the
line on the tray).
1
Fan the paper, and then tap the edge
against a flat surface to even the stack.
2
Insert the stack of paper into the tray,
PRINT SIDE DOWN.
•
If paper remains in the tray, take it out and combine it into a single stack
with the new paper.
•
Be sure to load the paper so that printing takes place on the print side of
the paper. Printing on the reverse side may result in poor print quality.
•
GENTLY LOAD THE PAPER IN THE PAPER TRAY.
•
DO NOT FORCE THE PAPER DOWN INTO THE FEED SLOT.
The stack should not be
higher than this line.
(This line is the reference
position for the maximum
number of sheets. If sheets
are above this line, press
down with your finger. If the
some sheets remain above
this line after this, please
remove.)
Note: Do not use paper that has already been printed on, or paper that is curled.
Note: If at any time the display shows the
alternating messages at right, check the printing
paper. If the tray is empty, add paper. If there is
paper in the tray, take it out and then reinsert it.
When you are finished, press
2
ADD PAPER &
PRESS START KEY
START/SPEICHER
.
Loading Printing Paper
paper in the paper tray
25