Sharp UX-D50 User Manual page 133

all.book Page 131 Monday, September 1, 2003 3:46 PM
FAX RX IN MEMORY
FUNCTION MODE
HOLD
INCORRECT FILM/
CHECK FILM
INTERCOM
LINE ERROR
MEMORY IS FULL/
SEE MANUAL
(alternating messages)
MEMORY PRINTING
NEAR END OF FILM/
REPLACE FILM
A fax has been received in memory because the
imaging film needs replacement, you have run out of
printing paper, or the paper is jammed. The fax will
print out automatically when the problem is fixed.
The FUNCTION key has been pressed.
The HOLD key has been pressed to place a call on
hold. Press the HOLD key again to resume the call.
The wrong type of imaging film is loaded in the
machine. Printing is not possible. The machine can
only print when SHARP UX-9CR imaging film is
loaded.
A cordless handset is paging the fax machine (lift the
handset to talk), or the fax machine is paging a
cordless handset. The name and number of the
cordless handset appear alternately with INTERCOM.
Transmission or reception was not successful. Press
the STOP key to clear the message and then try
again. If the error persists, see Line Error on page
124.
The memory is full. You may have too many
messages recorded in the answering system. To
erase messages, see page 68.
This message may also occur during fax reception if
too much data is received before the pages can be
printed out. If faxes have been received to memory
because printing is not possible (an additional
message will indicate the problem), resolve the
problem so that printing can continue (see Substitute
Reception to Memory on page 105). If you are
attempting to transmit from memory, see If the
memory becomes full on page 96. If you are copying,
see If MEMORY IS FULL appears on page 106.
The fax is preparing to or printing out a document
from memory.
This message appears 3 m from the end of the
imaging film (approximately 10 pages can still be
printed), and alerts you that you will soon need to
replace the film.
Messages and Signals
131