Alcatel-Lucent 1643 AMS User's Operation Manual page 676

Software upgrade
Parameters for upgrading the software of an NE
...................................................................................................................................................................................................................................
Introduction
The following parameters are used for Software Upgrade.
Active store
The software version of the executing code of the software loaded in the network
elements active store is described by four codes.
Code
Item Code
Com Code
Interchangeability Marker
Serial Number
Backup store
Shows the software load that is now stored in the backup store. The same codes are
used as in the active store.
Active store state
The following table shows the possible values.
Value
Active.
Active Not Committed
...................................................................................................................................................................................................................................
12-14
Description
A code used to uniquely identify any system
component.
A code which identifies the component.
An identification mark to indicate interchangeability
among components
A number that indicates the sequence number and the
year, date, and location of manufacture.
Description
Memory contains a valid code that is being executed.
If no association is made between the management system
and the network element after a software switch.
The software that was active before the switch is now in
the backup store. If the association is not made within 2
hours after the switch, the system will switch the stores
back so that the previous active software is made active
again. Therefore it is not wise to download software
while the active store is in this state.
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007