Traffic provisioning
Parameters for editing MSP protection
...................................................................................................................................................................................................................................
Working section
Displays the group of sections defined as working.
Protection section
Displays the group of sections defined as protection.
Active section
Displays which section is carrying traffic.
Switch state
Displays the current switch state of the protection pair.
Selected pair
Displays the selected sections and indicates the alarm status at the working/protection
port. This can be Error Free, Failed, or Degraded.
WTR (wait to restore)
WTR is the wait to restore time after the failure on the protected unit has cleared.
WTR (Wait to restore/Wait to rename)
Defines either the Wait to Restore Time or the Wait to Rename Time.
If MSP mode is ETSI, then WTR is the wait to restore time after the failure on the
protected unit has cleared. If MSP mode is 1+1 optimized, then WTR is the Wait to
rename: after the failure on the protected unit has cleared, the traffic remains on the
protection, but the current primary becomes secondary and the other way around.
Values are 0..60
...................................................................................................................................................................................................................................
8-196
Alcatel-Lucent - Proprietary
See notice on first page
365-312-807R7.2
Issue 4, May 2007