Alcatel-Lucent 1643 AMS User's Operation Manual page 646

Performance monitoring
Ethernet High Priority, Low Priority Traffic Monitor and User
Provisionable LS/SLS Threshold
...................................................................................................................................................................................................................................
When to use
The following procedure is performed when you want to enable the Ethernet High
priority and Low Priority Traffic monitor counters, to set the threshold values for the
Ethernet High Priority Traffic monitor and the granularity of the monitored period. The
high quality and low quality ethernet PM counters provides performance monitoring
for an ethernet pack based on traffic class and color information.
The Ethernet High Priority, Low Priority Traffic Monitor and User Provisionable
Note:
LS/SLS Threshold procedure is also applicable to X5IP.
Related information
The items below list other relevant information to this procedure:
• Procedure to set the SDH TP Mode, for the required prior setting of the ports to be
monitored. Refer to
•
"Concepts" (p. 10-3)
•
"Ethernet performance monitoring" (p. 10-12)
Before you begin
The items below gives information on tasks to perform before beginning the procedure:
• Proper LAN card must be installed in TS2 in order to be able to make performance
LAN measurements.
• A prerequisite for this procedure is to set
tree mode" (p.
• Cross connection should be enabled and VCG should be set to monitored.
• LAN and WAN ports should be changed to Network port role in the Virtual Switch
Information window.
High Priority and Low Priority Traffic Monitor
Follow this procedure in order to view the High and Low priority Traffic monitoring
counters and the User Provisionable LS/SLS Threshold.
...................................................................................................................................................................................................
Select
1
Result:
Configuration mode.
...................................................................................................................................................................................................
Select
2
Port and then click
...................................................................................................................................................................................................................................
10-64
"Provision ports" (p.
8-105).
→
Performance PM TP Configuration
The Select Performance Monitoring Points window appears in the PM
Ethernet HQ Traffic
Add
and
Alcatel-Lucent - Proprietary
5-59).
"Provisioning a virtual switch in spanning
.
or Ethernet LQ Traffic
Ok
.
See notice on first page
for PM Point Type and select the
365-312-807R7.2
Issue 4, May 2007