Equipment provisioning
Result:
concerning the selected slot and its associated slots.
...................................................................................................................................................................................................
Right-click on a slot or a unit and select
3
Result:
concerning the selected slot and its associated slots.
...................................................................................................................................................................................................
4
Select the desired operation from the selections at the top of the window.
...................................................................................................................................................................................................
If assigning units, use the pull-down menu for Main Unit and select the correct unit
5
corresponding to the displayed slot.
Result:
...................................................................................................................................................................................................
Click
6
Important! When assigning units during node creation, instead of the Provisioned
NE Components window, the window Node Creation - Provision Slots will
reappear.
Result:
Provisioned NE Components or Node Creation - Provisioned Slots appears again.
...................................................................................................................................................................................................
If creating a node, then click
7
Result:
Node Creation - Provisioned Slots) disappears.
E
N D
...................................................................................................................................................................................................
....................................................................................................................................................................................................................................
5-22
The
Assign NE Units to Slots
The
Assign NE Units to Slots
The correct unit appears as the new Main Unit/Interface.
OK
.
The desired operation for this slot is performed, and the window
The window Provisioned NE Components (or in the case of node creation,
O F
S T E P S
Alcatel-Lucent - Proprietary
window appears with information
Assign/Unassign
window appears with information
Finish
. Otherwise, click
See notice on first page
Provisioning slots
.
Cancel
.
365-312-807R7.2
Issue 4, May 2007